Install Submersible Pump
(not included)
Screw your pre-assembled pump discharge
assembly into your pump.
Position your pump and discharge assembly
in the back chamber of the skimmer so that
the top of the discharge assembly faces your
chosen discharge hole. Bring the flexible
pipe into the skimmer through the discharge
hole/UniSeal and attach it to your discharge
assembly.
Run the pump power cord over to the
power source and position the cord so that
it transitions out of the skimmer at the cord
notch; this will allow the Natural Landscape
Lid to sit flush on the skimmer.
Finishing Touches
Slide the mechanical media mat and mat holder
into position.
Slide the black mesh skimmer net into position.
During normal operation the skimmer net will
remove larger leaves and debris while the mat
will remove the smaller particles allowing the
clean water to flow into the pump chamber
area where it can be re-circulated back to
the pond, preferably via the appropriately
sized Blue Thumb Biological Waterfall Filter.
Place the Natural Landscape Lid on top of
the skimmer to disguise the skimmer within
the landscape.
9a
9b
9c
STEP 9
STEP 10
10c
10b
10a
a
b
c
a
b
c
