7
ASSEMBLY
TOOLS REQUIRED: PHILLIPS SCREWDRIVER, PLIERS
NOTE: TO ENSURE AN EASIER ASSEMBLY, WE STRONGLY ADVISE
ONLY FINGER TIGHTENING BOLTS DURING INITIAL ASSEMBLY. ONCE
ALL BOLTS ARE INSERTED, FULLY TIGHTEN ALL BOLTS. DO NOT
OVERTIGHTEN.
NOTE: BOLTS SHOULD BE INSERTED THROUGH WASHERS AND
THROUGH THE OUTSIDE OF THE FIRE PIT, THEN SECURED WITH
NUTS ON THE INSIDE.
STEP 1
Attach the four legs [A[ with the four
connectors [B] using two M6 x 12
bolts [H], M6 washers [I] and M6 nuts
[J] per leg.
Make sure the leg assembly is square
and loosely tighten all fasteners.
Leave fasteners loose until the top is
installed.
STEP 2
Attach the ring [C] to top of the
legs [A] using one M6 x 12 bolt [H],
M6 washer [I] and M6 nut [J] per leg.
Make sure the unit is still square, then
tighten all fasteners at both the top
and bottom of the legs.
A
A
B
H
H
I
I
C
J
J
