Blue Seal Evolution G592, Инструкция по установке и эксплуатации

Страница: 22 / 35

20
Gas Conversion and Specifications
7. Using a small flat blade screwdriver, unscrew and
remove the pilot injector and spring from the base of
the pilot burner.
8. Determine the correct injector size for the
corresponding gas from the rating plate attached to
the inner bulkhead adjacent to the manifold test point
behind the front control panel or from the table at the
rear of this section.
9. Refit the pilot injector and spring into the base of the
pilot burner and tighten a small flat blade screwdriver,
Do not over tighten.
10. Refit the nut to the base of the Pilot Burner and
tighten hand tight using a 11mm A/F spanner.
11. Refit the pilot burner to the pilot burner bracket,
ensuring that the pilot burner is correctly fitted into
the bracket and is correctly orientated in respect to the
thermocouple and piezo igniter electrode.
12. Refit the pilot burner clamp and secure with the 2 x
8mm screws, ensuring that the pilot burner,
thermocouple and piezo igniter electrode are correctly
positioned and secured. Tighten up the 2 x 8mm
screws.
13. Re-connect the gas supply tube to the base of the pilot
burner and tighten using a 11mm A/F spanner.
14. Refit the main burner supports to the base of the
chargrill, ensuring that they locate into the cut-outs at
the front and rear of the chargrill burner box and
around the pilot burner bracket.
15. Refit the pilot burner shield panel to the front inner
face of the chargrill and secure in place with the 2
screws.
16. Refit the main burner and ensure that the burner
locates into the cut-outs in the burner supports and
that the burner locates correctly over the main
injector.
17. Refit the end heat shield panel. (This is a slot fit onto
the front inner face of the chargrill).
18. Refit the left and right inner radiation panels (These
are a slot fit onto either side of the chargrill).
19. Refit the inner radiants and castings to the Chargrill.
Nut
Pilot
Injector
Spring
Pilot
Burner
Fig 23
Note Orientation
of Pilot Injector
Openings
Fig 24
Burner Location
Slots
Fig 25
Main
Burner
Fig 26