Blue Seal Evolution G505, Руководство по эксплуатации

Страница: 29 / 33

Gas Conversion and Specifications
27
Commissioning
Before leaving the converted installation;
1.
Check all gas connections for leakages using soapy water or other gas detecting equipment.
2. Check the following functions in accordance with the operating instructions specified in the
‘Operation’ section of this manual.
• Light the Pilot Burners.
• Light the Main Burners.
• Check the Low Fire Burner operation.
• Check the High Fire Burner operation.
• Ensure that all the controls operate correctly.
• Ensure that the operating pressure remains correct.
NOTE: If for some reason it is not possible to get the appliance to operate correctly, shut off the
gas supply and contact the supplier of this appliance.
Gas Specifications
- Australia / New Zealand Only
*
The burner operating pressure is to be measured at the manifold test point with two
burners operating at the ‘High’ setting. The operating pressure is ex-factory set, through the
appliance regulator and is not to be adjusted, apart from when carrying out gas conversion, if
required. (Refer to the ‘Gas Conversion’ section for details).
WARNING:
D
O NOT USE A
NAKED FLAME
TO CHECK FOR GAS LEAKAGES
.
Natural Gas LP Gas (Propane)
Open Burner
Main Burner Injectors Ø 2.45 mm Ø 1.50 mm
Pilot Burner ('PF' Option Only) 0.30 0.20
Griddle
Main Burner Ø 2.10 mm Ø 1.30 mm
Pilot Burner 0.35 0.23
Main Burner Ø 2.60 mm Ø 1.60 mm
Pilot Burner 0.35 0.23
Low Fire Ø 1.5 mm Ø 0.95 mm
Supply Pressure 1.13 - 3.40 kPa 2.75 - 3.40 kPa
Burner Operating Pressure 0.95 kPa (*) 2.6 kPa (*)
Gas Regulator Cap Screw
Oven
Burner Aeration Setting Fully open Fully open