Blue Seal E700 Pizza, Руководство пользователя

Страница: 5 / 15

-5-
Unpacking and Assembly
Each unit requires the handle, chimney and legs to be fitted. All these are packed
inside the oven. Single oven units also have a storage shelf with stainless steel tray
to be fitted between the legs. The tray is packed on top of the unit, the shelf under
the unit. Remove the oven wire rack, four tiles and the centre support bar.
Single Oven Units
The unit is attached to the wooden pallet by two packing straps. Remove and
discard.
Lift unit out and place on its back to enable the legs to be fitted. Attach with the nuts,
bolts, spring and flat washers supplied. Attach the storage shelf between legs and fit
stainless steel tray on top of shelf.
Lift unit up onto its legs and adjust feet as required to level the oven. Fit door handle
with the screws already in the door. Push chimney/hood assembly down into the rear
ducting until the stainless steel hood touches the top cover panels. Refit tile support
bar, and tiles. Oven wire rack when required can be positioned on top of the tiles or
higher on either of the side runners of the oven.
Double and Triple Units
Start with the bottom units (as marked on the packing). Remove and discard the two
packing strips which hold the unit to the pallet. Place units on its back to enable the
legs to be attached. Attach legs with the nuts, bolts, flat and spring washers
supplied. Lift unit onto its legs and adjust feet as required to level the oven. Fit the
door handle with the screws already in the door. Refit oven tile support bar and tiles.
Fit chimney into the rear ducting. Approximately 65mm (2½") should protrude above
the top corners.
Unpack upper unit(s).
Unscrew the rear brackets from the pallet. Remove the stainless steel side trim
pieces along the bottom of the unit. Lift unit onto the bottom unit taking care to align
the bottom chimney into the ducting of the Upper unit. This upper unit screws to the
bottom unit at the rear the same as it was attached to the pallet.
Attach door handle with the screws already in the door. Attach side trim pieces. Fit
chimney to the upper unit.
Location
This appliance must be installed with minimum clearances of:
LH side 150mm
RH side 150mm
Rear 150mm
INSTALLATION
This unit is to be installed on legs supplied.