Joystick
Connector
2 Servo output channels, and 1 digital output channel each capable of recording and playback
of up to 13 minutes of action for servos and output relay.
Digital channel output with relay and wire connection terminal ( rated 2 Amp @ 24 VDC )
Uses standard game joystick to control servos and digital output.
Manual control and Programmed servo, digital channel control
Many other features
Controller
Instruction
I
Blue Point
Pointing the Way to Solutions!
Engineering
http://www.BPEsolutions.com
(BPE No. PJS-0010)
Introduction
Puppet III Joystick- Servo Controller
The Puppet III Board is a manual dual channel
servo controller and interface capable of recording
up to 13 minutes of servo movement and
designed to connect with many standard game
control joysticks.
It features loop playing with variable delay
between loops, synchronized playback of several
modules, servo movement limit setting and a
single relay digital channel output.
Connections
Power Connector - The controller module requires between 7.5 and 9V DC (center positive
power connection) at 2 Amp to operate standard servos.
Servo Connectors - standard servo connector. Take note of the polarity of the connection. On
some servos yellow is used in place of white as the signal control line.
Record LED (R ) - Red LED flashes when waiting to start recording and is on continuously
during actual program recording.
Playback LED (P) - Green LED indicates playback in operation. Flashes during the delay
period for loop operation setting.
Mode Jumper - Move the jumper block to select either Recording or Playback mode.
Range Jumper - Select servo output pulse to either 1-2 msecs (90 degree range) or 0.5 to
2.5 msecs (180 degree range). Note that not all servos can rotate a full 180 degrees and if
using the 180 degree range take care that the servo is not driven against its mechanical
stops. (Servo will shutter, may also hum if driven past available range.)
Limit Jumper - Set to Yes if you wish to set the servo end position limits at start-up. In normal
play mode set to No.
Board Size: 3-1/4" L x 2-3/4" W
Copyright © 2002 Blue Point Engineering, All Rights Reserved
