Installation Instructions
TC6011 Bracket Kit
Insure that you use the proper TruCenter steering control unit for your application. Using too strong or too weak of a steering
control may result in improper or undesirable handling.
Product Safety Policy Statement
It is, and shall continue to be, a primary objective of Blue Ox Towing Products to provide customers with safe and reli-
able products. Blue Ox will, and has, established safety procedures in product design, manufacture, promotion and
sales; and will coordinate efforts to promote customer safety to the greatest extent possible. Each department has
primary responsibility for the promotion of safety under the guidelines of the Product Safety Committee.
Ground
Ground
Solid State
Solid State
Timer Relay
Timer Relay
Fuse Bus
Fuse Bus
6. Install small end of TruCenter unit to top of tie
rod bracket with Items 3/4"-10 x 3-1/2" bolt,
3/4" fl at washers and 3/4"-10 1.59 fl ange nut,
torque to 180-200 ft/lbs.
7. Tighten U-bolts on the Tie Rod Bracket to 30-
35 ft/lbs of torque, while maintaining an even
amount of threads extending past each nut.
Note: Check to be sure installed unit clears
all other parts of vehicle by turning steering
wheel to both extreme right and left positions.
If unit scrapes or binds at any point, make
necessary corrections by rotating unit on tie
rod to obtain necessary clearance. It may
also be necessary to dump the air from the
air suspension to insure that the RV's trac bar
and fuel tank to not come in contact with the
TruCenter.
8. Install TruCenter Steering Control wiring
according to instructions included in its
package.
9. DEALER OR INSTALLER: BE CERTAIN
USER RECEIVES INSTRUCTION SHEET.
If the TruCenter is in an accident, it must be replaced. DO NOT use it again! An accident can cause unseen
damage and using it again could result in more damage or serious injury. DO NOT use the TruCenter if it is
damaged or missing parts.
Shown above Freightliner Chassis XC with Air Bags, 150 Gal. Fuel Tank
405-00164 Rev. C
Page 2 of 3
3/18/14
