Patriot
®
Braking System
405-0260 Rev A
Page 3 of 12
2/14/14
Unpacking your Patriot
®
Remove the Patriot
®
and accessories from the shipping carton, review parts list and diagram below. Make sure
that you have the appropriate items shown below. If
NOT
, please contact a Blue Ox® Dealer or Distributor, or
call a member of the Customer Care Team at (402) 385-3051 to order replacement parts.
Contents:
1. Patriot
®
Unit
2. 2-Way RF In-Coach Controller
3. Brake Feet
4. Breakaway Switch
5. Breakaway Lanyard
6. Breakaway Cable
7. XL Top Fangs
Important:
USE ONLY GENUINE FACTORY REPLACEMENT PARTS. Do NOT substitute homemade or non-typical parts. This
may cause your brake to fail and result in injury or death. If repair parts or components are needed, you may order them
through your nearest Blue Ox
®
Dealer or Distributor, or call our Customer Care Team at (402) 385-3051.
1
2
3
4
5
6
To satisfy FCC RF exposure requirements for mobile and base station transmission devices, a separation distance
of 20 cm or more should be maintained between the antenna of this device and persons during operation. To
ensure compliance, operation at closer than this distance is not recommended. The antenna(s) used for this
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Safety & Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
7
