5. Using a 10MM socket, remove one bolt
located underneath the fascia just left of the
frame. Do this to both sides of the vehicle.
Pull the fascia forward to remove. Set fascia
and bolts aside to be reinstalled later.
6. Using a reciprocating saw, cut along the ridge
3/4” up and straight across to remove the
piece. Do this to both sides of the vehicle.
Page 4 of 6
292-2989 Rev B
09/9/14
8. Slide baseplate in where the tow hooks were
removed. Insert a 1/2-13 x1 1/4” hex bolt with
loctite and 1/2” lock washer into the two holes
on the side and the two holes on the bottom
of the baseplate and tighten bottom two down
first. Do this to both sides of the vehicle.
4. Using a 10MM socket, remove two bolts
located just behind the wheel well plastic that
we removed the bolts and push pins from.
Do this to both sides of the vehicle. Set bolts
aside to be reinstalled later.
4
5
6
8
BE SURE TO USE LOCTITE
®
RED ON ALL BOLTS
BEFORE TIGHTENING. TIGHTEN ALL BOLTS
ACCORDING TO THE TORQUE CHART ON THE
FRONT PAGE OF THESE INSTRUCTIONS OR ON
PAGE 3 OF THE BASEPLATE TOWING GENERAL
INSTRUCTIONS.
7B
7A
7. Using a 18MM socket, remove one bolt from
the side and one bolt from the bottom of the
tow hook. Do this to both sides of the vehicle.
Factory tow hooks and bolts will not be
reinstalled.
2007-2013 Chevy Suburban 2500
Installation Instructions
BX1678
