Page 5 of 6
405-0173 Rev. B
3/16/11
STEP 6
STEP 6
6. Attach with 1/2-13 x 1” hex bolt and 1/2-13
lock nut. Use Loctite on the bolt. Tighten with a
3/4” socket/wrench. Torque to 55 ft/lbs.
5. Using the BedSaver as a template with
a 7/32” drill bit, drill the hole in the front.
STEP 5
STEP 5
3. Using a 17/32” drill bit, drill two holes. There
will be 3 1/2” between the holes and 3/4” up from
the edge.
4. Install the BedSaver plate. Line up with
the holes and clamp. Attach with 1/2-13 x 1”
hex bolts with 1/2-13 lock nuts. Use Loctite on
the bolts. Using a square align the side of the
BedSaver at a right angle (90
o
) to the back edge
of the hitch (gray arrow step 3 photo). Then
tighten the bolts to 55 ft/lbs with torque wrench.
STEP 3
STEP 3
STEP 4
STEP 4
