Page 1
Section1 To the installer
Air Cooled Units
The model T15 ice cream machine’s air cooling unit require a minimum of 15.2cm of
clearance around both sides. Install the skirt provided on the right side of the unit and
place the back of the unit against a wall to prevent recirculating of warm air.
Electrical Hook-Up Installation For 50 Hertz, 1 Phase, Supplied With Cord and
Plug
This equipment is supplied with a 3-wire cord and grounding type plug for connection
to a single phase, 50 hertz, branch circuit supply. This unit must be plugged into a
properly grounded receptacle. The cord and plug provided for 230Volts, 50Hertz,
1Phase, is 8 Amp; therefore the wall outlet must also be 8 Amp. Check the data label,
located in the side panel, for electrical specifications. The plug should be accessible
after installation.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person in order to avoid a hazard.
Permanent wiring may be employed if required by local codes. Instructions for
conversion to permanent wiring are as follows:
1. Be sure the freezer is electrical disconnected.
2. Remove the appropriate panel and locate the small electrical box at the base of
the freezer.
3. Remove the factory-installed cord and strain relief bushing.
4. Route incoming permanent wiring through hole in base pan.
5. Connect two power supply leads. Attach ground (earth) wire to the grounding lug
inside the electrical box.
6. Be sure the unit is properly grounded before applying power.
Electrical Connections for Models Without Cord and Plug Supplied
Each freezer requires one power supply for each data label. Check the data label on
the freezer for fuse, circuit ampacity and electrical specifications refer to the wiring
diagram provided inside of the control box, for proper power connections.
This equipment is intended to be installed in accordance with the National Electrical
Code. The purpose of this code is the practical safeguarding of persons and property
from hazards arising from the use of electricity. This code contains provisions
considered necessary for safety. Compliance therewith and proper maintenance will
result in an installation essentially free from hazard!
CAUTION: THIS EQUIPMENT MUST BE PROPERLY GROUNDED! FAILURE TO
DO SO CAN RESULT IN SEVERE PERSONAL INJURY FROM ELECTRICAL
