Blue Giant EPJ-25, Руководство оператора

Страница: 3 / 24

EPJ-25 ELECTRIC PALLET JACK—OPERATOR’S MANUAL
3 ISSUE DATE: DECEMBER 7, 2020 REV. 1.0 (PART # 038-1074E)
1.0 SAFETY PROCEDURES
1. Do not operate this truck unless you have been trained and authorized
to do so.
2.
Do not operate this truck until you have read and understood all of the
safety information and instructions contained herein and on the truck.
3.
Do not operate this truck until you have checked its condition. Give
special attention to wheels, controls and lifting systems, including steering
mechanism, guards and safety devices.
4.
Report the need for truck repairs to your supervisor immediately and
do not operate truck until repairs are made. Neglect may cause a minor repair to
become a major service problem and cause the truck to become unsafe.
5.
Do not load truck beyond capacity shown on serial name plate on
truck.
6.
Do not lift with the fork tips or one fork only.
7. This equipment is designed for evenly centered loads with forks
completely supporting the load. Off-centering of loads can result in a dangerous
operating condition and may cause damage or injury.
8.
Always look in direction of travel. Use caution when visibility is
obstructed by load.
9.
Extreme caution must be used when handling loosely stacked/
packaged loads.
10.
Watch swing clearance when turning near walls, racks. pillars or other
obstacles.
11.
Start, stop, change direction and travel smoothly. Slow down for turns
and on uneven or slippery surfaces that cause truck to slide or tip. Be aware that
the truck behaves differently without a load than with a load.
12.
Observe applicable traffic regulations. Yield right of way to pedestrians.
13. Do not ride on this equipment.
14. Do not carry passengers or lift personnel.
15. Before you leave the truck, fully lower lifting mechanism.
2.0 EXCLUSION OF LIABILITY
The manufacturer assumes no liability for damage or injury to persons or
property which has occurred as a result of defects or faults in the hand pallet
trucks delivered or due to incorrect use. The manufacturer also assumes no
liability for lost profits, operating down times, or similar indirect losses which
the buyer has incurred. Damage to third parties, irrespective of its nature, is not
subject to compensation.
The operating instructions are not subject to notification of amendment.
The descriptions and illustrations included in our operating instructions and
replacement parts list are not binding.
In the interests of further development, we reserve the right to make any
changes at any time to the modules, components and accessories which we
deem to be expedient, or for technical reasons, while retaining the essential
features of the models described here.