Blue Eco Manual |
English
EN
Blue Eco start-up instructions
Dear Blue Eco user,
Thank you for choosing Blue Eco pumps! With these pumps you own the latest technology in variable pumps. Blue Eco pumps are the
most energy efficient pumps worldwide and are fitted with high tech features.
Your Blue Eco pump has a standard warranty period of 2 years after initial start up (optional expandable to 4 years). For a decent
warranty registration your pump has a maximum speed of 1200 RPM. This maximum speed is set by the manufacturer as a good speed
for “running in” the pump. After registration on www.blue-eco.nl you (or your supplier) will receive 2 codes that will release the full
speed of the pump. If you do not appreciate a personal registration you can register the pump on your supplier’s name/e-mail address,
the purpose of this registration is to have the serial numbers of the pump and controller on the initial day of use.
During registration at www.blue-eco.nl you will be asked for two internal serial numbers from the controller. These can be found as
follows:
1. Turn on the controller and wait for “0” in the display.
2. Press the ‘MENU’ button, the display will show ‘SYSTEM’.
3. Press ‘ENTER’ and press the yellow button with the
symbol 3 times.
4. ‘SERIAL NUMBER 1’ will appear in the display, write down this number.
5. Press the
button again and write down ‘SERIAL NUMBER 2’.
6. Press 2x on “MENU” to go back to starting display or do nothing for 30 seconds.
You now have the two desired serial numbers for registration. After you register by filling in these two serial numbers and the rest of the
data, you will immediately receive a reply email containing the relevant instructions:
Example:
You have registered your pump and received the two codes. Your registration is processed.
RPM activation code 1: xxxx
RPM activation code 2: xxxx
Your warranty period begins today.
Note! The pump must not be running when you enter the codes!
Follow the instructions below to activate the codes:
1. Turn on the controller and wait until ‘0’ appears on the display.
2. Press the ‘MENU’ button so that ‘SYSTEM’ appears on the display.
3. Press ‘ENTER’ (display shows ‘TIMER MODE’), then press the yellow button with the
symbol five times.
4. The display now shows ‘ACTIVE CODE !’ with four digits (e.g. 3998).
5. Enter the four digits of activation code 1 that you received by email: pressing ‘SELECT’ causes the fourth digit to begin flashing, and
you can now change its value with the
and
buttons.
