Blue Diamond Multi-Purpose Cutter, Руководство по эксплуатации и запасным частям

Страница: 25 / 41

25 Brush Cutters
888-376-7027
Blue Diamond Attachments, LLC
September 2020
4 .6 Detaching from Tractor
1. Place the cutter flat on the ground. If a
perpendicular configuration was used, place the
cutter in a flat configuration before disconnecting it.
2. Shut off the tractor, set the parking brake, and
remove the key.
3. Operate the tractor’s hydraulic levers to release all
pressure.
4. Unhook the supply (pressure) hose from the rear of
the tractor (manifold valve).
5. Unhook both hose quick disconnect fittings at the
front of the tractor. Make sure the fittings are kept
clean.
6. Lower parking stand (when applicable)
7. Release the locking latches and detach the lift arms
from the cutter .
4 .7 Cutter Checklist
Efficient and safe operation of the cutter requires that
every user read and understand
the operational instructions and all related safety
instructions outlined in this manual.
This Initial Setup Checklist is provided for the user/
owner. It is important for both personal safety and to
maintain the mechanical condition of the
cutter
that
this checklist is followed.
1. Although there are no operational restrictions on
the cutter when used for the first time, it is
recommended that the following mechanical items
be checked:
a.
After 1/2 hour of operation:
Tighten all fasteners if necessary. Lubricate
all grease fittings.
b. After 10 hours of operation:
Go to the normal servicing and maintenance
schedule, as defined in the Maintenance
Section.
2. Before each use of the
cutter
, the following
areas should be checked.
Cutter
Checklist Before Each Use
4
Task
Initially, retighten the tapered roller bearing
in the pivot arm after 15 minutes of initial
use and again at 30 minutes. Recheck
again before the next use.
Make sure the
cutter is positively
attached to the tractor.
Use only an appropriately sized tractor.
Refer to “5.3 Tractor Requirements” on page
24.
Make sure the hydraulic hose is properly
attached to the tractor.
Make sure all safety shields and guards are
properly installed.
Check the blade bolts and blade carrier nut.
Check the condition of the blades.
Inspect the overall
cutter for potential
problems or damage. Do not use the cutter
if it needs repairs of any type.