Blue Diamond Drum Mulcher, Руководство по эксплуатации и обслуживанию, Страница: 36 / 90

34
Drum Mulcher Operation and Maintenance Manual
Maintenance
Lubrication
DANGER
AVOID SERIOUS INJURY OR DEATH
Before servicing the Drum Mulcher:
• Lower the machine’s lift arms and place
the drum mulcher on flat, level surface.
• Engage parking brake, stop engine,
remove the key and exit the machine.
• Disconnect attachment hydraulic hoses.
WARNING
AVOID SERIOUS INJURY OR DEATH
DO NOT work under the machine lift arms in
the raised position without the lift arms
being properly locked or blocked (see
machine
operator manual for more
information.)
IMPORTANT
Fluid such as hydraulic fluid, coolants,
grease, etc. must be disposed of in an
environmentally
safe manner. Some
regulations require that certain spills and
leaks on the ground must be cleaned in a
specific manner. See local, state and federal
regulations for the correct disposal.
NOTE: Use high temperature with a dropping
point of minimum 340° (170°C) such as
Mobil PolyrexEM.
Below each of the three grease zerks is a grease
overflow port. Grease overflow during operation
may occur.
NOTE: Inspect the grease overflow port for signs
of liquid overflow. Liquid grease streaks
may be a sign of bearing overheating or
the operating temperature of the grease
used is too low.
Figure 6
Every 8 Hours: Lubricate the two grease zerks
(Item 1) [Figure 6] labeled “8 hour” located on
each side of the mulcher with three to four pumps
of grease each. The “8 hour” grease zerks
lubricate the cutting drum bearings.
Every 40 Hours: Lubricate the grease zerk (Item
2) [Figure 6] labeled “40 hour” located on right
side of the mulcher with six to eight pumps of
grease. The “40 hour” grease zerk lubricates the
hydraulic motor overhung load adapter bearings.
1
2