Blue Coat SG810 series, Руководство по установке

Страница: 63 / 110

P/N 231-02941 SG810 Installation Guide page 63
5
Click
OK
in the Take disk offline dialog that displays.
6
Close the Management Console.
7
Check the front panel Disk Drive LEDs: wait for the corresponding Disk
Drive LED to flash before you remove the disk.
Figure 3-2: Check the Disk Drive LED
8
See “Removing a Disk Drive” on page 64 for removal instructions.
To take a disk offline using the CLI:
1
Open a terminal session with the SG810 and enter the password when
prompted.
2
At the command prompt, type
enable
and enter your privileged-mode
password when prompted.
3
At the privileged-mode command prompt, enter the following command:
SGOS# disk offline disk_number
where
disk_number
is the number of the disk going offline, a number from
2 to 4.
4
Check the front panel Disk Drive LEDs: wait for the corresponding Disk
Drive LED to go off before you remove the disk (see Figure 3-2).
See Removing a Disk Drive , below, for removal instructions.
Check that the corresponding
Disk Drive LED is flashing
(this example shows that Disk
Drive 2 is offline)
An unlit LED indicates there is
no disk in the slot.