4.Now connect one end of the white pipe to the SS ball valve and
other end to the push fit on the hand side of the outer filter
labelled as water in. (Note: White pipe is for raw water supply)
5.Take one meter of white pipe and Connect one end of the pipe
with in outer filter push fit where water out is marked and connect
another end of the white pipe with machine where water- in is
marked.
6. Similarly, connect one end of the blue pipe to the connector
labeled as REJECT WATER in machine and leave the other end
in the drain. (Note: Blue pipe is for rejected water)
7.
Before connecting the power supply, it is important that
you perform the following functions:
i) Open the SS ball valve (Handle parallel to the ball valve) to
start the flow of water into the purifier.
ii) Wait for 2-3 minutes to ensure that the filters are soaked in
water.
Starting Up The Purifier
Switch on the power supply to get the purified water. Run the
machine at least for one hour .
.
Switch off the power supply.
Drain the first time purified water stored in tank to remove any
dust particles present in the pipes and storage tank.
Switch on the power supply.
Now
Bluebird Bluemoon
RO
Water Purifier
is ready to use.
Recommended Uses Of Reject Water
Although the rejected water has high concentration of salts, it is
absolutely clean and free of impurities like chlorine, dirt, sand,
etc. which are present in raw water. This rejected water usually
goes down the drain but if required, can be used for cleaning /
mopping purposes after disinfection.
Installation Instructions
4
