Blue Aura Blue 1, Руководство пользователя

Страница: 10 / 18

10
Operating Instructions
Before Operation
Place the Blue 1 on an even surface. IMPORTANT: Do not place any objects on top
of the Blue1. The ventilation slots located on top of the device must be unobstructed
at all times.
• Speaker connections
Make sure correct polarity is maintained at each speaker connector or the sound can become
weak. The red coloured speaker terminals are positive (+) and the black speaker terminals are
negative (-).
Note: All connections are made using standard loudspeaker cable. Loosen the terminal screws
one after the other and insert the stripped ends into the holes. Re-tighten the terminal screws.
You can also use prefabricated cables with 4mm banana plugs (If using 4mm plugs, the safety
plugs must be removed from the loudspeaker connection terminals) or forked fittings. Also
observe the operating instructions for the speakers you are using.
Connections
• Connect your audio sources.
• Connect the DAB/FM antenna to the antenna connection point at the rear of the device. For later operation, the position of the
antenna should then be determined according to where the best reception is. The end of antenna should then be secured in the
appropriate position.
Reception can be improved by a suitable indoor or outdoor household antenna if the reception is poor.
• Connect the supplied mains cable to the rear and then insert the other end into a socket.
• Actuate the on/off switch on the rear side, the device is now in the standby mode.
• Switch on the device using the remote control or with the ON/STBY key on the front.
• Select your desired audio source using the input selector switch (press then turn left or right) or with the keys on the remote control.
• Sub out
If an active subwoofer is used, connect via a standard single RCA/phono cable (often referred to
as a 'Sub-Link')