28mm Gibbet with Target
B28-ST-105
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Gibbet with Target (B28-ST-105)
Remove the two uprights and the base from the
sprue.
Glue the two uprights back-to-back, then glue them to
the base (as shown above) using the lugs/holes
provided.
Take the two side pieces and the two ‘feet’ from
the sprue.
Glue one of the ‘feet’ to each side piece as shown.
Glue one side piece to each side of the uprights,
using the holes/lugs provided.
Carefully remove the two brackets from the sprue.