28mm Walkway
–
Triple
B28-SF-228
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Front A - Open
Take the two pieces shown above from the sprue.
Glue the one on the left to the
back
of the one on
the right.
Take the barricade section…
..and glue it into position (see pic). Leave to dry.
Front B
–
Firing Point (do this twice)
Take the two pieces shown above from the sprue.
Glue the one on the right to the
back
of the one on
the left.
