10mm 3x2 Shops Foyer
B10-MW-108
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer (B10-MW-108)
Start by removing the long sides from the sprue
along with 2 of the corner bracers per side.
Glue the bracers into position (as shown above) and
glue one short side into place. Allow to dry.
Once dry, attach the sides together to form an
open box.
Glue the columns and balconies into position on each
of the long sides.
Then repeat this for the two short sides.