10mm 3x2 Industrial Roof
B10-CS-303
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Roof Section (B10-CS-301)
Remove the roof and four wall sections from the
sprue.
Glue them into position as shown above.
The Air-con unit is made from the four pieces as
shown.
Glue these together as shown above.
The glue the finished unit to the roof.
Finally add the decorative strips and supports.
