AT LEAST ONE COPY OF THIS MANUAL SHOULD BE KEPT IN A LOCATION AVAILABLE AT
ALL TIMES TO MAINTENANCE AND MANAGEMENT STAFF.
10 Sunnen Drive – St. Louis, MO 63143
MODEL POD2 DUAL POD BREWER
PREPARATION FOR USE
Before the first use, clean the brewer by completing a brew cycle as described below
without
using
a coffee pod.
BREWING COFFEE
1. Place brewer on a solid flat surface. Plug into 120V outlet.
2. Open filter basket by grasping basket handle and swinging outward. Insert a coffee pod into
filter basket. Use a fresh coffee pod for each brew. Return basket to closed position. To assure
safe operation, make sure basket is closed securely.
3. Lift the hinged water reservoir cover; pour water into reservoir opening. Marking on water level
indicator shows amount of water needed to make desired number cups of coffee.
FOR 1 CUP,
DO NOT EXCEED 1-CUP LEVEL ON THE WATER LEVEL INDICATOR.
FOR 2 CUPS, DO
NOT EXCEED 2-CUP LEVEL ON THE WATER LEVEL INDICATOR.
Close reservoir cover.
4. To brew 1 cup on left side, place cup onto drip tray on left, press left “BREW” button. To brew
1 cup on right side, place cup onto drip tray on right, press right “BREW” button. To brew 2
cups (one on each side), place two cups onto drip tray, press left and right “BREW” buttons.
LED will light. CAUTION: Brewer becomes very hot during brew cycle; handle with extreme
care as hot parts and escaping steam may cause burns.
5. At end of brew cycle, LED will flash and audible beep will signal brewing is complete. LED will
turn off, and brewer will switch off automatically.
6. After brewer and coffee pod(s) have cooled, carefully open filter basket and discard used
coffee pod(s). To remove filter basket from brewer, grasp basket handle and swing basket
outward, and with basket in far right position, lift up basket.
CLEANING AND MAINTENANCE
Always unplug brewer and allow to cool before cleaning. Wash filter basket in hot, sudsy water.
Wipe brewer with damp cloth and dry. Never put brewer in water or in the dishwasher. For hard to
remove stains, use a plastic mesh pad or a cloth dampened in vinegar. Do not use metal cleaning
pad or abrasive cleaners.
Minerals found in water can clog brewer or reduce its efficiency. To prevent this, add a mixture of
1/3 vinegar and 2/3 water to water reservoir.
DO NOT OVERFILL.
Place cup on drip tray and press
“BREW” buttons. After mixture has been cycled through, press “STOP” button. Rinse by cycling
through 2 or 3 more cycles of plain cold tap water. Do not pour any liquid other than cold tap water
or water with vinegar into reservoir opening when cleaning.
WARNING: SERVICING SHOUD BE PREFORMED BY
AUTHORIZED SERVICE FACILITY
P2_1311a
