7
HDE-2H/2S-QAM
Instruction Manual
Description:
Front panel connectors and indicators:
DATA OUT 1 GIGE:
RJ45 connector for GigE (1000Base-T Ethernet) interface for multiplexed SPTS or MPTS output streams. Only static IP address can be
assigned to this interface. The factory default value is 192.168.253.1.
REMOTE CONTROL 10/100:
RJ45 connector for 10/100Base-T Ethernet interface for monitoring and configuring the unit. Only static IP address can be assigned to
this interface. The factory default value is 172.16.70.1.
IP RESET:
When pushed and held for about 10 seconds, resets the IP address, Usernames, and Passwords to Factory default values as follows:
IP address = 172.16.70.1
Username = Admin (case-sensitive)
Password = pass (case-sensitive)
AUDIO & VIDEO LEDs:
LEDs indicate the status of audio and video of each of the four inputs as follows:
Audio LED
Green = Audio input type detected is Analog (L/R) or Digital Audio (PCM)
Red = Audio input with error
Off = Audio input not detected
Video LED
Green = Video input type detected is Component (YPbPr) or HDMI or HD-SDI
Red = Video input with error
Off = Video input not detected
ASI OUT:
The “ASI OUT” BNC connectors 1 to 4 delivers multiplexed SPTS or MPTS output and is typically used as input to an external modulator.
-20dB QAM RF TEST:
“F” connector for RF testing -20db referenced from the main output.
ENCODER:
LED indicates the status of the two internal encoder chipsets as follows:
LED is Blue = two encoder chipsets are encoding (no input signal needs to be present).
LED is Off = one or both of the of the encoder chipsets are not encoding, or their normal operating temperature has been
exceeded.
POwER:
LED is Green = AC power is detected.
LED is off = indicates (i) AC power is not connected, or (ii) AC power is connected but the power supply is defective. The unit must be sent
to Blonder Tongue for repair for condition (ii).
[4]
[5]
[6]
1
2
3
4
5
[6]
6
[6]
7
[6]
8
1
2
3
4
5
6
7
8
