Blomberg TKF 7431, Руководство пользователя

Страница: 14 / 36

14 /36 EN
Dryer / User Manual
3
Installation
Before the calling the nearest Authorised Service for the
installation of the dryer, ensure that electrical installation
and water drain is appropriate referring to the user's
manual.
(See 3.3 Connecting to the drain and 3.5
Electrical connection)
If they are not suitable, contact
a qualified electrician and technician to make necessary
arrangements.
C
Preparation of the dryer's location
as well as the electrical and waste
water installations is under customer's
responsibility.
A
Prior to installation, visually check if the
dryer has any defects on it. If the drier
is damaged, do not have it installed.
Damaged products cause risks for your
safety.
3.1 Appropriate installation location
• Install the dryer on a stable and level surface.
• Dryer is heavy. Do not move it by yourself.
• Operate your dryer in a well ventilated, dust-free
environment.
• The gap between the dryer and the surface should
not be reduced by the materials such as carpet,
wood and tape.
• Do not cover the ventilation grills of the dryer.
• There must not be a lockable, sliding or hinged door
that may block the opening of the loading door in
the place where your dryer is to be installed.
• Once the dryer is installed, it should stay at the
same place where its connections have been made.
When installing the dryer, make sure that its rear
wall does not touch anywhere (tap, socket, etc.).
• Place the dryer at least 1 cm away from the edges
of other furniture.
• Your dryer can be operated at temperatures
b5°C and +35°C. If the operating
conditions fall outside of this range, operation of
the dryer will be adversely affected and it can get
damaged.
• The rear surface of the tumble dryer shall be placed
against a wall.
B
Do not place the dryer
on the power
cable.
3.2 Removing the transportation
safety assembly
A
Remove the transportation safety assembly
before using the dryer for the first time.
• Open the loading door.
• There is a nylon bag inside the drum that contains
a piece of styrofoam. Hold it from its section
marked with
XX XX
.
• Pull the nylon towards yourself and remove the
transportation safety assembly.
A
Check that no part of the transportation
safety assembly remains inside the drum.
3.3 Connecting to the drain
In products equipped with condenser unit, water
accumulates in the water tank during the drying cycle.
You should drain accumulated water after each drying
cycle.
You can directly drain accumulated water through the
water drain hose supplied with the product instead of
periodically draining the water collected in the water
tank.