Blomberg MBS 3101, Инструкции по эксплуатации

Страница: 7 / 32

INSTRUCTIONS FOR THE
INSTALLER
INSTALLATION
All installation (electrical connection) procedures must be carried out by a skilled
engineer in accordance with the regulations in force.
ALL ADJUSTMENT, SERVICING ETC. PROCEDURES MUST BE CARRIED OUT
WITH THE APPLIANCE DISCONNECTED FROM THE ELECTRICITY SUPPLY.
POSITIONING
The appliance is designed for built-in installation, with dimensions above the appliance as
shown in figures “1” and “2”.
If the hob is combined with an oven, follow the instructions provided by the oven's
manufacturer, in all cases assuring ventilation as specified in fig. “
6
”. In all cases, the
electrical connections to the two appliances must be made separately, both for electrical
reasons and to simplify extraction.
This product has a special gasket to prevent liquids from seeping into the cabinet. The
gasket must be put carefully in place as shown in figure “
7
”.
Secure the hob with the brackets provided as shown in figure “
7
”.
ELECTRICAL CONNECTION
Before making the electrical connection, check that:
- The characteristics of the home's power supply comply with the requirements stated
on the nameplate provided underneath the hob and in this handbook;
- Ensure that there is an earth connection system in good working order;
- If the appliance does not have a power lead, use material complying with
characteristics stated on the nameplate provided underneath the hob and in this
handbook;
-
In case of direct connection to the mains, an omnipolar circuit-breaker with contact
breaking gap of at least 3 mm must be installed on the power supply line in an easily
accessible position close to the appliance (there must be no break in the yellow-green
earth wire).
THE MANUFACTURER ACCEPTS NO LIABILITY IN CASE OF FAILURE TO COMPLY WITH THE
ABOVE INSTRUCTIONS AND WITH NORMAL ACCIDENT PREVENTION STANDARDS.
-
Characteristics of the Barbecue cable: 3x1,5 IMQ (H05V2V2-F)
-
Characteristics of the Fryer cable: 3x1,5 IMQ (H05V2V2-F)
5