Blomberg LTK2802W, Руководство пользователя

Страница: 16 / 36

EN 16 / 36
Dryer / User Manual
Make sure that you have an earthed power outlet socket
rated at 13 amps (minimum).
4.1 Attention!
When installed, the socket must be reachable after
installation, or a separate switch (which can disconnect
the two poles) must be used in the installation. Check for
suitability.
For a permanent connection, a master switch with at
least 3mm contact clearance and minimum 13 A rating
must be used.
4.2 Electrical requirements
Before you insert the plug into the wall socket make sure
that the voltage and the frequency shown in the rating
label corresponds to your electricity supply.
We recommend that this appliance be connected to the
mains supply via a suitable switched and fused socket in
a readily accessible position.
Should the mains lead of the appliance become
damaged or need replacing at any time, it must be
replaced by a special purpose made mains lead which
can only be obtained from a Authorised Service Agent.
A
Warning
This appliance must be earthed
If the fitted moulded plug is not suitable for your socket,
then the plug should be cut off and an appropriate plug
fitted.
The moulded plug on this appliance incorporates a 13A
fuse. Should the fuse need to be replaced an ASTA
approved BS1362 fuse of the same rating must be
used. Do not forget to refit the fuse cover. In the event
of losing the fuse cover, the plug must not be used until
a replacement fuse cover has been fitted. Colour of the
replacement fuse cover must be the same colour as
that visible on the pin face of the plug. Fuse covers are
available from any good electrical store.
In order to avoid hazards, damaged supply cord should
be replaced by the manufacturer, its service agent or
similarly qualified people.
Built-under installation
This appliance can be installed under a worktop.
A
Do not operate without the top cover
fitted. Risk of injury.
A
Important
4.3 Fitting a different plug
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals on your plug, proceed
as follows:
1 Connect the green - yellow or green (earth) wire to the
terminal in the plug marked ‘E’ or with the symbol or
coloured green and yellow or green.
2 Connect the blue (neutral) wire to the terminal in the
plug marked ‘N’ or coloured black.
3 Connect the brown (live) wire to the terminal in the
plug marked ‘L’ or coloured red.
With the alternative plugs a 13A fuse must be fitted
either in the plug or adaptor or in the main fuse box. If in
doubt contact a qualified electrician.
4.4 Washer/dryer combination
Do not stack washing machine on top of the tumble
dryer. This would damage both appliances and
guarantees would become void. It is also unsafe to
stack an appliance on top of another without using a
suitable and approved stacking kit obtained from the
manufacturer of the appliances.
• A special stacking kit is required as an optional extra
please contact customer service.
Green and yellow
or green
N
Blue or black
L
Brown or red
4 Electrical Connection