9
Dryer / User Manual
3 Installation
Before the calling the nearest Authorized
Service for the installation of the dryer, ensure
that electrical installation and water drain is
appropriate referring to the user’s manual.
If they are not suitable, contact a qualified
electrician and technician to make necessary
arrangements.
C
NOTE
• Preparation of location and electrical
installation for the product is under
customer’s responsibility.
B
DANGER!
• Installation and electrical connections
must be carried out by a qualified person.
A
WARNING!
• Prior to installation, visually check if the
product has any defects on it. If so, do
not have it installed. Damaged products
will cause risks for your safety.
3.1 Appropriate installation location
• Install the product in an environment
which has no risk of freezing and is in a
stable and level position.
• Operate your product in a well ventilated,
dust-free environment.
• Do not block the air ducts in front of and
under the product with materials such as
long pile rugs and wooden bands.
• Do not place your product on a long pile
rug or on similar surfaces.
• Do not install the product behind a door
with a lock, sliding door or a hinged door
which can strike the product.
• Once the product is installed, it should
stay at the same place where its
connections have been made. When
installing the product, make sure that the
rear wall of it does not touch anywhere
(tap, socket, etc.) and also pay attention
to install the product at a place where it
will stay permanently.
B
DANGER!
• Do not place the product on top of the
power cable.
• Keep at least 1.5 cm distance to walls or
other furniture.
• The rear surface of the tumble dryer shall
be placed against a wall
• This dryer is not able to be wall-mounted
as it would be too too heavy for the walls.
3.2 Ventilation hose and connection
(for products equipped with an outlet
vent)
Ventilation hose allows exhaust air from inside
the machine
Vented dryer has 1 air outlet.
Stainless sheet metal or aluminum pipes can
be used instead of a hose. The pipe diameter
should be minimum 10 cm.
Maximum hose and pipe lengths are given in
the table below.
Hose
Pipe
Maximum length
4 m
5 m
1 elbow 45°
-1.0 m
-0.3 m
1 elbow 90°
-1.8 m
-0.6 m
1 elbow 90° short
-2.7 m
1 wall passage
-2.0 m
-2.0 m
C
NOTE
• Each elbow and other passages should
be subtracted from the maximum length
stated above.
To connect a ventilation hose;
1. Connect the air outlet hose to the
hose spacer piece by turning it
counterclockwise.
2. Make the hose passages as shown
below.
