Blomberg LDF30110W, Руководство пользователя, Страница: 14 / 41

Dishwasher / User manual
13 / 40
EN
Preparation
Remove the test
strip from the
packet.
Turn on the tap and
let the water run for
about a minute.
Hold the test strip in
the water for about
a second.
Remove the test
strip from the water
and shake it.
Wait for 1 minute. The test strip shows
you the hardness
level.
After determining hardness level of the supply water:
1. When the Programme Selection key is at “Off” position, keep Start/Pause/Cancel
key pressed and turn the Programme Selection key to position “1” within 5 seconds.
Machine will enter into the regeneration adjustment mode at the end of this period.
2. Regeneration level in the memory will be illuminated for 5 seconds when the
regenerator adjustment mode is activated.
3. To adjust the new Water Hardness Level, move the Programme Selection key
to the position that is suitable for your supply water. (see, “Water Hardness Level
Adjustment Table”)
4. Press Start/Pause/Cancel key for once to store the level you have selected.
Machine returns to the normal operating mode after the new setting is stored.
* Programme Selection key rotates in 5 steps regardless of the number of the
programmes contained on the machine.
5. Press “Start/Pause/Cancel” key for once to store the level you have selected.
Water hardness level adjustment table
Hardness
Level
English Water
Hardness °dE
German Water
Hardness °dH
French Water
Hardness °dF
Position of
Program
Selection Key*
Water Hardness Level Indicator
0th Level
0-5 0-4 0-8 1
Washing lamp on the panel will
illuminate.
1st Level
6-9 5-7 9-13 1
2nd Level
10-15 8-12 14-22 2
Drying lamp on the panel will
illuminate.
3rd Level
16-19 13-15 23-27 3 End lamp on the panel will illuminate.
4th Level
20-24 16-19 28-34 4
Washing, Drying and End lamps on
the panel will illuminate.
5th Level
25-62 20-50 35-90 5
Washing, Drying and End lamps on
the panel will flash with an interval of
1 second.
If the hardness level of the supply water is above 90 °dF or if you are using well
water, then it is recommended to use water purification devices and special filters.
If the hardness level of the supply water is below 13°dF, there is no need to use salt
in your dishwasher. If this is the case, “No Salt Warning Indicator” (if any) illuminates
continuously on the panel of your machine.
If the water hardness level adjustment is set to level 1, the “No salt warning indicator”
will illuminate continuously although it is not necessary to use salt. If you use
salt under this condition, salt will not be consumed and the Salt indicator will not
illuminate.