EN
6
For models with
water dispenser
• Pressure for cold water
inlet shall be maximum
90 psi (6.2 bar). If your
water pressure exceeds
80 psi (5.5 bar), use a
pressure limiting valve
in your mains system. If
you do not know how
to check your water
pressure, ask for the
help of a professional
plumber.
• If there is risk of water
hammer effect in your
installation, always
use a water hammer
prevention equipment
in your installation.
Consult Professional
plumbers is you are not
sure that there is no
water hammer effect in
your installation.
• Do not install on the
hot water inlet. Take
precautions against
of the risk of freezing
of the hoses. Water
temperature operating
interval shall be 33°F
(0.6°C) minimum and
100°F (38°C) maximum.
• Use drinking water only.
Electrical
Requirements
Before
you
insert
the plug into the wall
socket make sure that
the voltage and the
frequency shown on the
rating plate inside the
appliance corresponds to
your electricity supply.
Rating label is on the left
hand side of inner liner.
We recommend that this
appliance be connected
to the mains supply via a
suitable
switched
and fused socket. The
appliance
must
be
positioned so that the
plug is accessible.
Should the mains lead
of the appliance become
damaged or should it
need
replacing at any time,
it must be replaced by
a special purpose made
mains lead which can
only be obtained from a
BLOMBERG
Authorised
Service Agent.
