EN
13
Installation Instructions
1.
The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
2.
Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance
to work less efficiently. If installed
next to a source of heat or freezer,
maintain the following minimum side
clearances:
From Cookers 50 mm (2”)
From Radiators
300 mm (12”)
From Freezers 25 mm (1”)
3.
Make sure that sufficient room is
provided around the appliance to
ensure free air circulation. Fit the two
plastic wall spacers supplied with the
appliance to the condenser on the
back of the appliance by rotating 1/4
turn. (See Diagram).
4.
The fridge/freezer should be located
on a smooth surface. The two front
feet can be adjusted as required.
To ensure that your appliance is
standing upright adjust the two front
feet by turning
clockwise or
anti-clockwise, until the product is
in firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
5.
Refer to cleaning and care section
to prepare your appliance for use.
A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back
of the cabinet, on the side of the
compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage.
6.
Fit the front grille supplied with your
appliance as shown in the diagram.