EN
9
REVERSING THE DOORS
We recommend that you reverse doors
before switching on for the first time.
Tools required:
Small and medium size
flat and cross-headed screwdrivers, a
pair of pliers.
Spare
Parts supplied in the plastic
bag: The following parts, which are
exclusively for left hand side fitted
hinge operation are supplied in a
plastic bag with the appliance:
- Upper door top trim hinge covers –
there are 2 different parts, one for each
side of top trim.
- Upper door middle hinge bushing/
door stopper assembly.
We suggest you keep all the parts
supplied in the plastic bag and also
parts, which have been removed when
reversing doors, in a safe place for
possible future, re-use.
IMPORTANT:
We suggest you ask
somebody to help you when moving
the appliance around and to hold
doors when removing / re-fitting
hinges and doors to avoid any injury
and damage to the product.
Please refer to diagrams supplied. To
follow numbers in brackets below,
refer to the main diagram.
1.
Switch off the appliance at the
socket outlet and pull out the
mains plug.
2.
Remove all food, loose items and
fittings from inside the appliance and
door shelves.
3.
Carefully tilt the appliance on
its back side. (1) (You may need
somebody to help you.) Take care not
to damage the appliance by laying
on some protective material (e.g. its
original packaging). Make sure that
you tilt the appliance on its back side,
otherwise compressor oil may block
the pipes and you may damage the
appliance.
4.
Unscrew and remove the LHS front
feet and bolt (2).
5.
Unscrew the bolts and remove the
bottom hinge while holding the door
(3).
6. Remove the door carefully from the
top hinge by sliding down wards (4).
7.
Reposition top hinge bushing and
blanking plug on the opposite side and
stand the door safely (5). You may find
it easier to remove the bushing and the
plug with the tip of a small screwdriver.
Take care not to mark the door.
8.
Reposition the top hinge on the
opposite side (6 and 7).
9. T
o refit the door, locate the top
hinge in the door, attach to the cabinet
and hold the door (8).
10.
Fit the bottom hinge (9). If
necessary adjust and then tighten the
bolts. Ensure, that the door opens
and closes easily and that there are
no gaps allowing air into the cabinet. If
there are gaps between the door seal
and the cabinet, adjust the door seal
by gently pulling away from the door
using fingers.
