Blomberg DV 17600 W, Руководство пользователя, Страница: 23 / 28

23 / EN
Dryer / User Manual
8 Troubleshooting
Problem Cause Explanation / Solution
Drying process
takes too long.
*Lint filter may not have been
cleaned.
* Clean the lint filter.
* Meshes of the filter may be
clogged. Wash with water.
*Ventilation grids on the front side
of the machine are blocked.
*Remove the objects (if any) that
block ventilation in front of the
ventilation grids.
*Ventilation is not sufficient since
the room where the machine is
installed is very small.
*Open the door and window
of the room to avoid the room
temperature increase too much.
*Lime deposit has built up on the
dampness sensor
*Clean the dampness sensor.
*Excessive laundry is loaded. *Do not load the dryer in excess.
*Laundry is not spun sufficiently
*Spin your laundry at a higher
speed in your washing machine.
Dryer does not
switch on or the
program does not
start. Dryer does
not start when
set.
* It may not plugged in.
* The loading door may be ajar.
* Program may not be set or the
“Start/Pause/Cancel” button may
not have been pressed.
* “Childproof lock” may be
activated.
* Make sure that the dryer is
plugged in.
* Make sure the loading door is
properly closed.
* Make sure the program has been
set and it is not in “Pause” mode.
* Deactivate the childproof lock.
Program is
interrupted for no
reason.
* The loading door may be ajar.
* Electricity may be cut off.
* Make sure the loading door is
properly closed.
* Press the “Start/Pause/Cancel”
button to start the program.
Laundry has
shrunk, become
felted or has
deteriorated.
* A program not suitable for the
laundry type might have been used.
* Dry only the laundry which is
suitable for drying in the dryer. First
check the labels on the clothes.
* Select a program a suitable low
temperature setting for the laundry
type to dry the clothes.
“End / Anticrease”
LED flashes.
* The 2-hour anti creasing program
to prevent laundry from wrinkling
may have been activated.
* Turn off the dryer and take the
laundry out of the dryer.
“End / Anticrease”
LED is on.
* Program has come to an end.
* Turn off the dryerand take the
laundry out of the dryer.
“Filter cleaning”
LED flashes.
* Lint filter may not have been
cleaned.
* Clean the lint filter.
* Meshes of the filter may be
clogged. Wash with water.
The “Drying” LED
flashes.
* A heat sensor failure has
occurred. dryer ends the program
without heating.
* Turn off the dryer and remove
the laundry. Call the authorized
service.
NOTE: Call an authorized service if the problem persists.