14
SETTINGS
This section explains the use of the setup menus on your LINE BLOCK, which allow you to customize and
configure the unit.
GENERAL CONTROL / NAVIGATION
Press & hold the Rotary/Push Button longer than two seconds, or press Menu Button on Block Remote to show
the Setup Menu on the display.
When the Setup Menu is active, use the Rotary Button, or Up/Down/Left/Right Buttons on Block Remote to
navigate, move the cursor through menu and to adjust parameters.
The Rotary/Push Button, or Select Button on Block Remote use to select and deselect options.
After selection of the DEFAULT option in the current menu, the default values will be returned.
After selection of the SAVE option in the current menu, the changes will be saved.
After selection of the CANCEL option in the current menu, the menu will move back a level in the menu
structure without changes saving.
After press Menu Button on Block Remote again will Setup Menu exit without changes saving.
After press & hold the Rotary/Push Button, or Select Button on Block Remote longer than two seconds, the
changes will be saved and the Setup Menu exits.
SETUP MENU Base-Level
Move the cursor to the desired position and then choose an option according the table below via Rotary/Push
Button, or via Select Button on the Block Remote.
STANDBY: After the selection, the Preamp / System switches to the Standby state.
BATTERY: This option lets you change the power supply mode:
•
ON: Battery operation
•
CHRG: Battery charging
•
OFF: AC Mains operation
POWER AMP. / OUTPUT: This option lets you control the Mono Block units and the Line Block outputs:
•
AUTO: The Mono Block units and the Line Block outputs will switch off/on after plug/unplug the Phones.
•
ON: The Mono Block units and the Line Block outputs will be enforced to On and remain in this state.
•
OFF: The Mono Block units and the Line Block outputs will be enforced to Off and remain in this state.
1)
Appears only when Block Audio Mono Blocks are installed in the system.
SETUP Menu
OPTIONS
DEFAULT
STANDBY
STANDBY after Enter, or 5 sec. countdown
STANDBY after 5 sec.
BATTERY
ON / CHARGE / OFF
ON
POWER AMP.
1)
/ OUTPUT
AUTO / ON / OFF
AUTO
SETTINGS >
Moves to the SETTINGS Menu
None
CANCEL
Exit the Setup Menu
None
Содержание LINE BLOCK
Страница 5: ...5 ...
