Block IR 100, Инструкция по эксплуатации

Страница: 29 / 43

Instruction Manual Wi-Fi Internet / FM Radio Model: IR 100
_____________________________________________________________________________________________________________
28
Step 3 - Connect to the wireless network
When the ESSID for the access point you want to connect to is displayed on the screen, press the SELECT
button.
If your network is not configured to need an encryption code, the screen should say:
Connecting to
Network
Then:
Network OK
If the screen displays either:
Enter WEP key
Or:
Enter WPA key
Then the network is using one of the encryption systems: Wired Equivalent Privacy (WEP) or Wi-Fi
Protected Access (WPA). You therefore need to enter the correct WEP or WPA code into the radio to get it
to communicate with your network.
Only the person who set up the network in the first place knows this code; if that person is not you then you
need to find out what it is.
After 3 seconds, the display goes into the code entry mode. To enter the code, use the knob to select each
character of the code in turn, pressing the
SELECT button after each character. Note that WEP and WPA
codes are sensitive to upper and lower case characters so you must enter them exactly.
After the final character, use the knob to select the END character and press the SELECT button.
The radio should now be able to connect to the network.
Choosing a radio station to listen to
1. Press the SELECT button to return to the top-level menu.
(Note: if you make a mistake at any point, press the BACK button to go back to the previous
screen.)
< Stations >
2. If the screen does not say < Stations > as shown above, turn the knob until it does.
3. Press the SELECT button.
4. Turn the knob to choose from <Location> or <Genre>.
<Location> enables you to choose from the radio stations provided by any country which you
choose from a list.
<Genre> enables you to choose radio stations according to their content, for example Classic
Rock, Sport, News, etc.