Blizzard SPEEDWING 7600HD, Руководство пользователя

Страница: 21 / 24

Lit. No. 57992, Rev. 02 21 April 15, 2021
HYDRAULIC HOSE AND FITTING
REPLACEMENT
DO NOT use thread sealant/tape on hoses or fi ttings.
This could damage product. Follow recommended
replacement procedures for
fi ttings and hoses.
1. Lower the snowplow completely.
2. Carefully note hose routing for proper reassembly.
3. Loosen hoses or fi ttings slowly to relieve any
residual pressure.
4. To remove a hose, loosen and unscrew the hose
fl are nut from the fi tting.
5. To remove a fi tting, loosen the jam nut and
unscrew the fi tting from the port.
Procedure for Installing Hydraulic Fittings
and Hoses
NOTE: Overtightening JIC hose fi tting ends will
result in a fractured fi tting.
DO NOT use any type of sealant or tape on the
fi ttings or hoses. This could damage product. Always
use two wrenches to ensure proper tightening of
fi ttings and hoses.
WARNING
Lower the blade when the vehicle is parked.
Keep 8 feet clear of the blade when it is being
raised, lowered, or angled. Temperature
changes could change hydraulic pressure,
causing the blade to drop unexpectedly or
damaging hydraulic components. Failure to
do this could result in serious personal injury.
MAINTENANCE
Use the following procedure to install SAE O-ring
fi ttings in valve block and rams:
1. Turn jam nut on fi tting as far back as possible.
2. Lubricate O-ring with clean hydraulic fl uid.
3. Screw fi tting into port by hand until the washer
contacts the port face and shoulder of the jam nut
threads.
4. Unscrew fi tting to proper position, no more than
one full turn.
5. Using two wrenches, hold fi tting body in position
and tighten jam nut until the washer again
contacts port face, then tighten an additional
1/8 to 1/4 turn to lock
fi tting in place. Final torque
on the jam nut should be approximately 20 ft-lb.
Use the following procedure to install hydraulic
hoses:
1. Screw fl are nut onto fi tting fl are and hand tighten.
2. Align hose so there are no twists or sharp bends
and so that it will not be pinched or pulled by
moving parts.
3. Using two wrenches, hold the hose in position
and tighten fl are nut 1/8 to 1/4 turn beyond hand
tight. Final torque on the fl are nut should be
approximately 20 ft-lb.
Once all parts are installed, top o ff the hydraulic fl uid
level as recommended by the skid steer manufacturer.