ELECTRICAL
Please ensure that the required voltage of the compressor is being supplied at all times.
Low or high voltage can detrimentally affect the refrigeration unit.
All units should be plugged into a grounded and properly-sized electrical outlet with
appropriate overcurrent protection. Please refer to the electrical requirements on the
nameplate of the unit. Please make sure that your unit has its own dedicated outlet. Do
not use an extension cord.
Adjusting the Set Temperature
1. Press and hold the set button for 3 seconds till the C led starts blinking with the
current set temperature shown
2. Use the arrow keys to adjust to the required set temperature setting.
3. Press the set key to store, then leave for approx. 5 secs till the display shows the
cabinet temperature, the cabinet will then cool down to the new set temperature.
NOTE!
The temperature shown on the display will fluctuate during normal use as the
unit regulates the cabinet temperature.
LOADING PRODUCT
Shelves have been factory-installed for your convenience. Before loading shelves,
please be sure that all shelf clips are completely fastened in their correct locations. It is
important that all shelves rest completely level before stocking your cabinet with product.
In order to maintain correct air flow inside the unit, please be sure to leave 50 mm to 100
mm of space between the back wall and stored product. Blocking the evaporator fans
will result in a warmer cabinet temperature, and ultimately compressor failure. Products
must be pre-chilled / pre-frozen before loading into the cabinet.
All electrical work must be carried out by suitably qualified
persons