Pentland Wholesale Ltd. Page
8
of
13
6.
Putting Into Operation
6.1.1
Switching On/Off
Switch on operation switch and the control panel should illuminate and display the
current temperature within the cabinet. Simultaneously the compressor pilot light
should activate. In the event of a power failure or interruption, the compressor will
normally restart after a slight delay when power is restored.
6.1.2
Temperature Display
During normal functioning, the cabinet temperature will be displayed on the
controller as soon as the unit is switched on.
6.1.3
Setting The Cabinet temperature
By pressing the
SET
button for 1 second, it is possible to read the set temperature.
To change the temperature press
SET
and press the switch
Λ
(Up) or
V
(Down) to
respectively increase or decrease the temperature from the preset. After selecting
the desired temperature confirm this by again pressing
SET
All the manual controls are on the right hand side of the unit. The controls are
shown in the illustration below:
1
2
6
3
5
4
1.
Defrost Light
2.
Compressor Operation Light
3.
Temperature Adjustment Keys
4.
Digital Thermostat
5.
Set Key
6.
Defrost Button
