Installing Your Cooler
Unpacking Your Cooler
1.
Remove all packaging material. This includes the foam base
and all adhesive tape.
2.
Inspect and remove any remains of packing, tape or printed
materials before powering on the cooler.
Levelling Your Cooler
•
You cooler has four feet for levelling, these are located
underneath at the four corners of the cooler. After properly
siting your cooler, you can begin levelling it.
•
Levelling feet can be adjusted by turning them clockwise to
raise your cooler or anti-clockwise to lower. The cooler door
will close easier when the feet are extended.
Proper Air Circulation
•
To ensure your cooler works at the maximum efficiency it was
designed for, you should site it in a location where there is
proper air circulation, plumbing and electrical connections.
•
It is recommended that you leave approx 50mm clearance on
all sides of the cabinet
•
Do not overfill your cooler for proper internal air circulation
Electrical Requirement
•
Ensure there is a suitable power outlet (220 – 230~volts,
15amps outlet)
•
Only use an earthed plug
Instalment Limitations
•
Do not install your cooler in any location not properly
insulated or heated e.g. garages etc. This cooler is not
designed to operate in temperatures lower than 13˚C
•
Select a suitable location for the cooer on a hard, even
surface away from direct heat sources such as radiators,
cookers etc. Any unevenness on the floor should be corrected
with the levelling feet
•
Your cooler is designed for free standing installation only. It
is not designed for built-in application.
