Page 11
The Puck: Unplugged RGB Manual Rev. A
Copyright (c) 2011 Blizzard Lighting, LLC
NOTE: After making any adjustment, the fi xture will return to the correct mode
after approximately 5 seconds.
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fi xture is DMX, which appears as
Addr
on the LED
Readout. Use the <ENTER> button then the <UP> and <DOWN> buttons to
choose a channel between
1
and
512
. Press <ENTER> again to confi rm.
2.) To change between 3 and 6 channel DMX mode, select
ChNd,
then press
<ENTER>. Select either
7Ch
or
4Ch
, then press <ENTER> again to con-
fi rm.
Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):
Allows you to link up to 32 units together without a controller.
1.) Use standard DMX cables to daisy chain your units together via the DMX con-
nector on the rear of the units.
2.) Choose a unit to function as the Master. Select MAST. The master unit must
be the fi rst unit. Finally, chain the units together using DMX cable.
Master
SLNd
then
NASt
to
confi rm.
3.) Select slave function by using the <UP>/<DOWN> keys to reach SLAV in
the Master/Auto menu on the slave units, and they will react in the same as the
Master.
Slave
SLNd
then
SLAu
to
confi rm.
4.) On the master fi xture, use the <UP>/<DOWN> keys to reach SHND, which
allows you to select the Master/Slave mode.
Sound active
SoUn
then <ENTER> to confi rm.
Auto mode
CoLo
then
Auto,
then <ENTER> to confi rm.
Color preset
CoLo
then
CoL 1 - CoL 15,
<ENTER>.
To set a custom color in Master/Slave / Standalone Mode:
Using this function, you can select any color by adjusting the Red, Green, Blue and Amber
values from 0-255. You may also adjust the color balance of the fi xture.
Please note that modifying the values in this step will affect ALL modes, therefore
we recommend resetting all levels to their highest value (255) after using this
mode.
1.) Select
NAnu
from the control panel, then hit <ENTER>.
2.) Choose
rEd, GrEE
,
bLuE or Uhit
, then hit <ENTER> to confi rm.
3.) Using the <UP>/<DOWN> keys, select the color you wish to display by
varying Red/Green/Blue intensity between 0 and 255, then hit <ENTER> to
confi rm each color choice.
4.) Select Color preset mode as instructed above, then select
CoL 15.
then
<ENTER> to confi rm.
To Show the Fixture Running Hours:
1.) Select
FhrS
from the control panel, then hit <ENTER> to confi rm.
