Page 12
Stiletto Beast™ User Manual - Rev. A
(c) 2016 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Set the Starting DMX Address:
1.) Navigate the main menu until you reach
Address,
press
<ENTER>
.
2.) Use the
<UP/DOWN>
buttons to select a DMX channel from
001-512
.
3.) Press the
<ENTER>
button to confirm.
Select the DMX Channel Mode:
1.) Navigate the main menu until you reach
User Mode,
press
<ENTER>
.
2.) Use the
<UP/DOWN>
buttons to select
Standard (26CH), Extended RGBW
(45CH)
or
Extended (54CH).
3.) Press the
<ENTER>
button to confirm your selection.
DMX512 and Art-Net Mode:
1.) Navigate the main menu until you reach
Intro,
press
<ENTER>
.
2.) Use the
<UP/DOWN>
buttons to select
DMX512,
or
Artnet
.
3.) When
DMX512
is selected, signal can be sent/received through the 3/5-pin
DMX connections, and when
Artnet
is selected, signals can be sent/recieved
through the RJ45 connections.
Slave Mode:
1.) Navigate the main menu until you reach
Intro,
press
<ENTER>
.
2.) Use the
<UP/DOWN>
buttons to select
Slave
.
3.) Press the
<ENTER>
button to confirm.
Auto, Sound Active, & Manual Adjustments:
Allows a single or Master/Slaved units to run factory installed programs.
Auto Mode:
1.) Navigate the main menu until you reach
Intro,
press
<ENTER>
.
2.) Use the
<UP/DOWN>
buttons to select
Auto1
or
Auto2
.
3.) When using either auto run mode, the unit can be used as a master fixture
with other linked fixtures that are set to
Slave.
Sound Active Mode:
1.) Navigate the main menu until you reach
Intro,
press
<ENTER>
.
2.) Use the
<UP/DOWN>
buttons to select
Sound1
or
Sound2
.
3.) When using either sound active mode, the unit can be used as a Master fixture
with other linked fixtures that are set to
Slave.
Static Mode:
1.) Navigate the main menu until you reach
Intro,
press
<ENTER>
.
2.) Use the
<UP/DOWN>
buttons to select
Static
.
3.) When
Static
is enabled, manual
0-255
adjustments found in
Intro > Static
are active. These are the same settings found in 26CH Standard DMX mode.
Calibration Settings:
1.) Navigate to
Intro <ENTER>
, then
Calibration <ENTER>.
2.) Use the password 033 to enable editing of the values within for Pan, Tilt, Zoom,
and Zoom (Lens) Rotation 0-255
.
3.) Press the
<ENTER>
button to confirm.
