Blizzard Lighting N-Trance, Руководство пользователя

Страница: 12 / 28

Page 12
N-Trance™ User Manual - Rev. A (c) 2018 Blizzard Lighting, LLC
DMX / Art-Net Modes
Allows the unit to be controlled by any universal DMX controller.
Set the Starting DMX Address:
1.) Navigate the main menu to reach DMX Address, press <ENTER> .
2.) Use the <UP/DOWN> buttons to select a DMX channel from 001-512 .
3.) Press the <ENTER> button to confirm.
DMX512 and Art-Net Modes:
1.) Navigate the main menu to reach MODE, press <ENTER> .
2.) Highlight DMX Signal Select, press <ENTER> .
3.) Highlight DMX or Artnet, press <ENTER> .
4.) When DMX is selected, signal can be sent/received through the 3-pin DMX connections, and
when Artnet is selected, signals can be sent/received through the RJ45 connections.
Select the DMX Channel Mode:
1.) Navigate the main menu to reach MODE, press <ENTER> .
2.) Highlight DMX Mode , and press <ENTER> .
3.) Use the <UP/DOWN> buttons to select DMX 21Ch, DMX 44Ch or DMX 128Ch, and press
the <ENTER> button to confirm.
Network Setup: (Artnet)
1.) Navigate the main menu to reach Network Settings, press <ENTER> .
2.) Use the <UP/DOWN> buttons to navigate through the network setup options.
IP Address = Set the IP address
xxx.xxx.xxx.xxx
Press the <ENTER> button repeatedly
to cycle through each set of 3 digits
1-4. Use the <UP/DOWN> buttons to
change the value of each from 000-255.
Subnet Mask = Set the subnet mask
xxx.xxx.xxx.xxx
Press the <ENTER> button repeatedly
to cycle through each set of 3 digits
1-4. Use the <UP/DOWN> buttons to
change the value of each from 000-255.
Universe = Set the universe Choose from 000-255.
Slave Mode:
1.) Navigate the main menu to reach DMX Address, press <ENTER> .
2.) Use the <UP/DOWN> buttons to highlight Slave, press <ENTER> .
3.) Press the <ENTER> button to confirm.
4.) If a control signal is not present the display will flash, otherwise it will not flash.
Auto, Sound Active, & Manual Adjustments:
Allows a single or Master/Slaved units to run factory installed programs.
Auto Mode:
1.) Navigate the main menu until you reach MODE, press <ENTER> .
2.) Use the <UP/DOWN> buttons to highlight Auto, then press <ENTER> .
3.) Choose Auto Program (to run) or Auto Speed, and press <ENTER> .
4.) You can adjust the Auto Speed anywhere ranging from 000-255 (slow <--> fast).
Sound Active Mode:
1.) Navigate the main menu until you reach MODE, press <ENTER> .
2.) Highlight Sound, then press <ENTER> to confirm.
3.) Adjust the mic sensitivity using the <UP/DOWN> buttons to adjust the mic Sensitivity
(0-255), and press <ENTER> .
Static Mode:
1.) Navigate the main menu until you reach MODE, press <ENTER> .
2.) Highlight Static, then press <ENTER> to confirm.
3.) Select and adjust any function from 000-255. Use the same DMX values that start on p.14.