Page 12
Kryo.Morph™ User Manual - Rev. A
(c) 2016 Blizzard Lighting, LLC
Changing The Lamp
DANGER:
Install the lamp with the fixture unplug from mains!
WARNING:
Do not touch the lamp’s envelope with bare hands. Should this
happen, clean the bulb with a cloth soaked in alcohol and dry it.
1.) First disconnect the fixture from mains and allow it to cool for at least 20
minutes.
2.) Remove the lamp compartment cover from the rear side of the head by tak-
ing out the 4 phillips head screws that hold it in place.
3.) Remove both electrical fastons from the flat blades of the lamp.
4.) Holding the lamp by its ceramic base, carefully pull it outwards until it snaps
free from the spring locks that hold it in place, and remove the old lamp from
the compartment.
5.) Holding the new lamp by its ceramics base, insert it into the lamp compart-
ment until it snaps into place (held by the spring locks).
Note:
Do not install a lamp with a higher wattage!
A lamp like this will generate temperatures this fixture is not designed for.
Damages caused by non-observance are not subject to warranty.
6.) Slide both fastons onto the new lamp blades
7.) Reinstall the lamp compartment cover.
Never operate this fixture without the lamp!
Do not operate this fixture without the lamp cover!
Phillips
Head
Screw
Phillips
Head
Screw
Lamp Compartment Cover
(rear side of the head)
Phillips
Head
Screw
Phillips
Head
Screw
