Blitz Master Wheel 50, Руководство по эксплуатации, Страница: 4 / 18

4
106431 03/15
Operating Instruction
Introduction
2.4 Instructions for adhering to the
operating instructions
•
Knowledge of the fundamental safety in-
structions and the safety regulations is a
basic precondition for safe handling and
undisturbed operation of the short lifter.
• The operating instructions must be ad-
hered to by all persons that work on the
short lifter. This applies in particular to the
chapter on “Safety / accident prevention”.
• The rules and regulations that apply at the
place of operation must also be adhered to
in addition to the safety instructions in the
operating instructions.
2.5 Operator obligations
The operator is obligated to only allow such
persons to work on the system as
•
are aware of the fundamental regulations
concerning work safety and accident pre-
vention and have been instructed in the
handling of the system
•
have read, understood and confirmed by
signature the safety chapter and warnings
in these operating instructions.
2.6 Dangers in handling the Master
Wheel 50
Danger
The Master Wheel 50 must only be
operated for its designated purpose in
perfect and safe working order.
Faults that may affect the safety must
be rectified immediately.
The appliances are designed and constructed
on the basis of state of the art technology and
the recognised technical safety regulations.
Nonetheless, improper use may result in a
risk for the life and limb of the operator or in
material damage.
•
Never operate the appliance in areas that
are exposed to the risk of explosion.
•
Only use the appliance on an even, firm
surface.
• Only move the appliance when this would
not endanger any persons.
•
Keep the area in which the Master Wheel
50 moves free.
• Persons must not enter the area in which
the Master Wheel 50 moves!
•
Do not exceed the maximum load bearing
capacity.
• Do not climb on to the Master Wheel 50,
travel with it or climb on to the load!
•
Carry out lifting, lowering and moving
evenly. Observe the load during transport.
Organisational measures
• Keep the operating instructions accessible
at all times at the place of operation of the
short lifter.
•
In addition to the operating instructions,
general statutory and other binding regu-
lations concerning accident prevention
and environmental protection must be
observed and publicised!
•
Monitor at least occasionally during opera-
tion that the staff operate the appliance
in accordance with the safety and danger
instructions!
•
Use personal safety equipment whenever
necessary or specified in regulations!
• Observe all safety and danger instructions
on the wheel assembly trolley!
•
Ensure that all safety and danger instruc-
tions on the wheel assembly trolley are
legible!
• Do not make any changes, additions or
modifications to the wheel assembly trol-
ley which may impede the safety without
the approval of the manufacturer! This ap-
plies in particular to welding load-bearing
components.
• Spare parts must conform to the technical
requirements specified by the manufactur-
er. Only original parts can guarantee this.
•
Periods prescribed or specified in the
operating instructions for cyclic examina-
tions / inspections must be adhered to!
•
Switch off and secure the Master Wheel 50
immediately in the event of faults! Rectify
any faults immediately!