5
f e a t u r e s a n d s p e c i f i c a t i o n s
Frequency response
Input impedance
Input sensitivity
Maximum output
Channel separation
S/N ratio
THD
Power supply
Dimensions
10Hz-30KHz
22K Ohm
0-7V
15 Volts
60dB
>90dB
0.05%
10-16V DC, negative ground
1.3"H x 3.6"W x 5.2"D
1 LOW LEVEL INPUT
2 HIGH LEVEL INPUT
3 INPUT LEVEL CONTROL
4 LED POWER ON INDICATOR
5 +12V POWER INPUT
6 GROUND
7 REMOTE
8 OUTPUT TERMINALS
Low level input RCA jacks used to connect to the output of the signal source.
NOTE: DO NOT CONNECT THESE HIGH LEVEL INPUT WIRES IF YOU ARE USING
THE LOW LEVEL INPUT RCA JACKS.
Turning this control clockwise to increase the level.
LED indicator lights up when the internal switching power supply is activated and
the unit is operational.
To be connected to the positive terminal of your vehicle battery or other constant
+12V source.
To be wired to the vehicle's chassis ground.
NOTE: GROUND WIRE SHOULD NOT BE EXTENDED MORE 3FT (1 METER)
To be connected to the remote control wire or antenna lead of the source unit for
remote on/off.
RCA jacks used to connect to the amplifier.
