To Charge the capacitor:
1. Make Capacitor positive terminal connections with amplifier and tighten the
bolt. Do not over-tighten the bolts!
Caution:
Stripped terminals are not covered under the capacitor’s warranty.
2. Connect the ground cable with battery, amplifier, then refer to the attached
drawing.
3. Place the supplied charging bulb or resistor between the positive terminal of
the capacitor and the battery’s positive terminal. Do this for 30 seconds or
until the charging bulb goes out.
Caution:
The charging bulb will get hot!
4. Immediately after the charging process, take out the charging bulb from the
connecting wire. And connect the positive cable of the battery directly to the
positive terminal on the capacitor.
DISCHARGING THE CAPACITOR:
WHEN YOU WANT TO MOVE THE CAPACITOR FROM ORIGINAL
INSTALLED CAR AUDIO SYSTEM, YOU MUST FIRST FOLLOW
DISCHARGING PROCESS AFTER TAKING OUT THE CAPACITOR FROM
THE CAR AUDIO SYSTEM.
To Discharge the capacitor: With battery power disconnected, place the light bulb or
resistor across the capacitor’s positive and negative terminals until light goes out or
for three minutes if using a resistor.
3
