5
f e a t u r e s a n d s p e c i f i c a t i o n s
Power source
Input current
Distortion
Frequency response
S/N ratio (A weighted)
Separation
Crossover frequencies
(continuously variable)
Low-pass
High-pass
Crossover slope rate
Subwoofer boost
Input impedance
Output impedance
Output voltage level
Dimensions
14.4 volts DC negative ground
0.5 amp max
0.01% THD at 1 V output level
10Hz-30KHz
±
3 dB
> 95dB
60 dB
35-400 Hz
80-2.5K Hz
12 dB per octave 2
nd
Order Butter worth
Single 12dB at 45 Hz
> 10K Ohms
<1K Ohms
5 volts max
160mm (W) x 130mm (D) x 37mm (H)
1.SIGNAL INPUTS
2.LOW PASS SUBWOOFER OUTPUT
TERMINALS
3.HIGH PASS CHANNEL OUTPUT
TERMINALS
4.FUSE
5.POWER INPUT TERMINAL (12V)
6.REMOTE TURN-ON INPUT TERMINAL
(REMOTE)
7.GROUND INPUT TERMINAL
8.POWER INDICATOR
9.HIGH PASS GAIN CONTROL
10.SUBWOOFER STEREO/MONO SWITCH
11.HIGH-PASS FREQUENCY SELECTOR
12.PHASE INVERTER
13.BASS-BOOST LEVEL CONTROL (45Hz)
14.LOW PASS SUBWOOFER FREQUENCY
SELECTOR
15.SUBWOOFER OUTPUT LEVEL REMOTE
CONTROL TERMINAL.
16.LOW PASS SUBWOOFER OUTPUT GAIN
CONTROL
To be connected to the output of the source unit.
To be connected to the subwoofer channel amplifier left/right inputs.
To be connected to the channel amplifier left/right inputs.
This crossover uses 1-amp, blade-type fuses for protection from power surges or a short
circuit.
To be connected to the positive terminal of your vehicle battery or other co12V source.
To be connected to the remote control wire or antenna lead of the source unit for remote
ON/OFF.
To be wired to the vehicle's chassis ground.
This indicator lights up when the internal switching power supply is activated and the unit
is operational.
For adjusting the channel output signal level.
For selection of stereo or mono mode subwoofer output.
For selection of high-pass crossover frequency between 80 Hz and 2.5KHz
Position the switch to the "180" position shifts the subwoofer output signals 180 degrees out-
of-phase relative to the front and rear output signals.
For increasing the Bass boost level up to +12dB.
For selection of the low-pass crossover frequency for the subwoofer channel between 35 Hz
and 400 Hz.
To be connected to the remote control for exclusive maneuver of the subwoofer output level,
and the subwoofer output level control on the unit ("16" below) is by-passed.
For adjusting the subwoofer channel output signal level.
FEATURES AND SPECIFICATIONS SUBJECT TO CHANGE AND / OR IMPROVEMENT WITHOUT NOTICE.
