5
f e a t u r e s a n d s p e c i f i c a t i o n s
Adjustable bass
boost and bass
frequency (40Hz- 400Hz)
Selectable crossover
frequency
- Subwoofer (Low Pass)
- High Pass
Power supply
Input impedance
S/N ratio
Slope Rate
Max output signal level
Channel separation
Distortion
Dimensions
40Hz-400Hz
40Hz-8kHz
10-16V DC, negative ground
10K Ohm
more than 85dB
12dB/Octave
7.0V RMS
60dB
less than 0.05%
1.8"H x 8.3"W x 5.9"D
1. INPUT LEVEL CONTROL
2. SUBWOOFER FREQUENCY CONTROL
3. BASS BOOST LEVEL CONTROL
4. FREQUENCY MULTIPLIER
5. HIGH PASS FREQUENCY CONTROL
6. SUB-MODE SELECTOR
7. SUBWOOFER SELECTABLE PHASE
SHIFTER
8. SUBWOOFER STEREO/MONO SELECTOR
9. SUBWOOFER GAIN CONTROL
10. HIGH PASS GAIN CONTROL
11. REAR CHANNEL INPUT PORT
12. FRONT CHANNEL INPUT PORT
13. LINE OUT PORT
14. SUBWOOFER OUTPUT PORT
15. HIGH PASS OUTPUT PORT
16. POWER TERMINALS
17. LED POWER ON INDICATOR
Turning this control to adjust the input sensitivity of the set to match the radio's output.
For selection of the Low-pass crossover frequency for the subwoofer channel between 40Hz
and 400Hz.
For increasing the bass boost level up to +12dB.
Positioning this switch at the "x10" changes crossover points from 40Hz-800Hz to 400Hz-
8kHz for high frequency high channel drivers.
By turning the selector you can choose the high-pass crossover points from 40Hz-8kHz.
Allows subwoofer mode channel to receive signal from either the mix of front Low-pass inputs
directly (when head unit has appropriate 5ch/6ch outputs)
Allows you to change the phase of your subwoofer 0 or 180 degrees to help compensate for
timing differences between drivers.
For selection of stereo or mono mode subwoofer output.
For adjusting the subwoofer channel output signal level.
For adjusting the high pass channel output signal level.
To be connected to the rear channel outputs of the source unit.
To be connected to the front channel outputs of the source unit.
To input additional amplifiers, crossover or Audio system.
To be connected to the subwoofer channel amplifier left/right inputs.
To be connected to the front channel amplifier left/right inputs.
Use these connectors to deliver power, ground and remote turn-on control to the unit.
The LED indicator lights up when the internal switching power supply is activated and the unit
is operational.
REMOTE CONTROL UNIT
1 SUBWOOFER LEVEL CONTROL
This control sets the subwoofer level control.
2 BASS FREQUENCY CONTROL
This control sets the frequency of the bass boost effect from 40Hz to 400Hz.
All manuals and user guides at all-guides.com
