3
2. Connect the ground cable with battery, amplifier, then refer to the
attached drawing.
3. Place the supplied charging bulb or resistor between the positive
terminal of the capacitor and the battery’s positive terminal. Do this
for 30 seconds or until the charging bulb goes out.
Caution:
The charging bulb will get hot!
4. Immediately after the charging process, take out the charging bulb
from the connecting wire. And connect the positive cable of the
battery directly to the positive terminal on the capacitor.
5 Follow attached wiring drawing to connect all wire and parts.
Below is an illustration showing correct wiring for the capacitor.
Multiple Capacitor Wiring Diagram
Use a separate ground for the Capacitor as shown in the figure.
Do not connect the capacitor to the same ground that is used for the amplifiers.
WHEN YOU WANT TO MOVE THE CAPACITOR FROM
ORIGINAL INSTALLED CAR AUDIO SYSTEM. YOU MUST FIRST
PROCESS DISCHARGING PROCESS AFTER TAKE OUT THE
CAPOACITOR FROM THE CAR AUDIO SYSTEM.
4
BU LB
D IS C H AR G IN G
To Discharge the capacitor: With battery power disconnected, place the
light bulb or resistor across the capacitor’s positive and negative terminals
until light goes out or for three minutes if using a resistor.
One Year
Warranty from the date of purchase.
