READ BEFORE INSTALLING HAMMOCK CHAIR
CAUTION
If you are not familiar with construction, hardware or the use of tools, please use a qualified general contractor to install. Improper installation may cause injury.
SAFETY FIRST:
Before entering a hammock chair, inspect your hammock chair, hardware, installation points and objects supporting your hammock chair for wear or
weakness. Proceed carefully and take your time getting into and out of your hammock chair. Any hammock chairs may tip if your weight isn’t centered. A hammock chair is
not a playground swing or a trampoline. Do not swing or twirl on your hammock chair. Excessive swinging and other rough play may result in falls and may wear out your
hammock chair and hardware prematurely. Small children should not play unsupervised in your hammock chair.
2
ALIGN EYE SCREW WITH THE
PILOT HOLE & HAND TIGHTEN
3
MAKE SURE TO TIGHTEN EYE SCREW
ENOUGH TO COVER ALL THREADS
5/16 INCH
STRAIGHT BIT
NOTE: Drill & drill bit not included.
INTO THE BOTTOM OF A
HARDWOOD TREE BRANCH
HARDWOOD TREE BRANCH should have at
least a 12-inch diameter (OR a circumference
that is greater than 37.5 inches )
To facilitate tightening, use a
screwdriver to rotate Eye Screw
clock-wise by threading it through
the Eye Screw’s hole.
1
PRE-DRILL 2-INCH DEEP
PILOT HOLE USING A
12-in+
thick branch
2-inch deep pilot hole
under tree branch
DO NOT USE UNLESS PRODUCT IS PROPERLY INSTALLED
IMPORTANT:
When using the included Eye Screws, first drill a 2-inch deep pilot hole
using a straight 5/16-inch bit. Then tighten each eye screw all the way in the hardwood
tree before hanging your hammock chair. (Illustrated directions below)
RECOMMENDED TOOLS
(NOT INCLUDED)
Electric Drill
5/16-inch Striaght Bit
Screwdriver
(for leverage when tightening)
NOTE: Ideally, screwdriver shaft should be
at least 6 inches long by 1/4-inch thick
